Notes On The Installation Of Conventional Thermostats
Leave a message
1. Wall mounted as shown, with a height of about 1.2 meters, generally in the same water parallel line with the electrical lighting switch. Installed in the surrounding air free flow of the wall, not affected by other heat sources (such as sunlight), door and window airflow or outside wall temperature, etc.
2. Pre-embedded electrical concealed box in advance, the depth of the concealed box should be more than 50mm. Due to the wall dark box space restrictions, the initial installation of thermostats will likely encounter small space, difficult-to-run lines, and pressure inequality problems. Please check the manual carefully and prepare for the installation. (If the existing home modifications generally choose the bright wire box, direct wall bright installation).
3. thermostat power wiring to stay away from high-voltage lines or high-current power cables, avoid parallel or for the same wiring with power lines. Recommend the use of independent conduit or with sheath shielding; try the temperature controller and generate strong high-frequency noise or surge devices are separated, or in the peripheral devices that generate noise (especially motors, inverters, solenoids, and other equipment with inductive components) on the installation of surge suppressors or noise filters.
4. If the configuration of external sensors, sensor installation needs to be pre-buried casing, to ensure the installation, maintenance, and plugging convenience. The casing should be sealed at ground level to prevent moisture and debris from entering. The sensor is installed in the middle of the two heating cables to ensure that the measured temperature can represent the ground temperature. It also serves to monitor the temperature of the ground to prevent overheating. To prevent overheating as the main limiting ground temperature sensor probe position, determine the set value of the limiting temperature.
5. thermostat temperature calibration, a combination of the above reasons, the temperature detected by the thermostat will be different from the actual temperature, so the last need for thermostat temperature calibration action, that is, to find the mercury thermometer, measuring sofa, bed and other places where people often appear, and then into the thermostat advanced options within the thermostat, the temperature detected by the thermostat correction so that it is consistent with the temperature of the mercury thermometer so that for thermostat subsequent use of temperature will be more accurate.
Finally, it is recommended that the installation of the thermostat system by a professional electrical installer operation, will not appear due to the installation of incorrect location and the system temperature inaccurate and can not be used normally.








